MIPI I3C Controller IIP

• Compliant with MIPI I3C version 1.2 specifications.
• Full MIPI I3C Secondary Master Functionality.
• Two wire serial interface up to 12.5 MHz using Push-Pull with the following Data rates supported:
  • Standard speed Supports all topologies
  • Single Master – Multi Slave
  • Single Master – Single Slave
  • Multi Master – Multi Slave
  • Multi Master – Single Slave
• Legacy I2C Device co-existence on the same Bus instance
• Dynamic Addressing while supporting Static Addressing for legacy I2C devices.
• Supports I3C address arbitration.
• Supports Single Data Rate (SDR) messaging.
• SDR with Direct CCC
• SDR with Broadcast CCC
• Supports High Data Rate (HDR) messaging
• HDR-Dual Data Rate Mode (HDR-DDR)
• HDR with Direct CCC
• HDR with Broadcast CCC
• In-Band Interrupt support and Hot-Join support
• Support for all I3C Common Command Codes(CCCs)
• Auto-Reject for In-Band Interrupt and Hot-Join (NACK and directed DISEC CCC to disable)
• Supports MCTP counters for IBI in Slave Mode
• Supports interrupt masking
• Fully synthesizable.
• Static synchronous design.
• Positive edge clocking and no internal tri-states.
• Scan test ready.
• Simple host interfaces enable straightforward integration with microcontrollers and application processors.
• This core achieves ASIL B and can be made to achieve ASIL D as per ISO26262.

CORE: Core module interconnects all the sub-modules in the Master IP. Ports of core module are the top level ports for the Master IP. SCL clock is derived from i_clk based on prescaler value.

GLITCH FILTER: Glitch filter is used to remove the spikes shorted than 50ns in duration for Legacy I2C mode.

PRESCALER: Prescaler module is used to divide the system clock based on the given prescaler value to derive the serial clock (SCL) input for I3C.

MASTER FSM: Master FSM module process the commands once pending request from CSR and host controller bus is enabled.For write transfer master FSM will send slave address, R/W bit,Write data and waits for ACK/NACK from slave.

SLAVE FSM: Slave FSM module process MIPI I3C commands once Start is detected.Slave FSM responds to MIPI I3C commands ACK/NACK for Write transfer and Read data for read transfer.

START: Initially SCL and SDA lines remains High, all transactions begin with a START condition. Start module detects the start condition on bus based on SDA and SCL line.

STOP: All transitions terminates with stop condition. Stop is detected based on SCL and SDA line. When SDA line goes from LOW to HIGH and SCL remains high is considered as the Stop condition.

HDR EXIT RESTART: In HDR Mode all transfers terminates with HDR exit pattern or HDR Restart pattern. HDR Exit Restart module detects the HDR exit pattern or HDR Restart pattern.

CSR: CSR module has all the registers. The contents of the registers are decoded and assigned to its respective output ports based on its functionality.

• Single Site license for regional development teams.
• Multi-Site license for global corporate deployments.
• Single Design license for specific project cost-efficiency.
• Unlimited Design license for high-volume product roadmaps.

• Complete Verilog/VHDL/SystemC Source Code.
• UVM-compliant verification environment with a comprehensive test suite.
• Production-ready synthesis, Lint, and CDC scripts.
• IP-XACT RDL generated address maps.
• Standard-compliant firmware and Linux/C driver packages.
• Detailed documentation: User Guides, Release Notes, and ISO 26262 Safety Manual (SAM)/FMEDA.